- Timber on a galvanised steel frame
- Sealed all six faces before hanging
- Tip-up or sectional mechanism
A wooden garage door is chosen for appearance, and it earns that choice on the right house. In Kempton Park we fit them on the larger homes through Glen Marais, Serengeti and Pomona, and on older properties where a modern steel panel would look wrong on the elevation.
Wooden garage doors we supply in Kempton Park
- Hardwood sectional doors with the panel construction that suits the elevation.
- Timber tip-up doors on new or existing frames.
- Timber-clad steel doors where the look is wanted with less maintenance.
- Meranti and other hardwoods, selected for stability rather than only for grain.
Mass, and the one place timber wins here
Timber is heavy, which is usually a complication. Under a flight path it is also an advantage: a solid timber door has real mass, and mass is what actually blocks sound. A well-made timber sectional with proper perimeter seals performs well on noise, and on the right house it is both the best-looking and the quietest option.
Weight, and what it means for the rest of the door
That mass has consequences through the whole installation. The frame has to carry it, the balance has to be rated for the finished door rather than the previous one, and the operator has to be sized on the real mass. A timber door on hardware specified for a steel one fails early and takes the hardware with it.
Timber and the Highveld climate
West-facing garages take hard afternoon sun, and the swing between dry winters and heavy summer storms moves timber more than most owners expect. A door sealed on all six faces, including the top and bottom edges nobody sees, moves far less than one finished only where it shows.
Maintenance, stated honestly
A timber garage door needs recoating. On a sheltered opening that might be every three or four years; on a west-facing one in full sun it is sooner. We give the interval for your specific opening at survey, because a customer who was not told is a customer with a warped door and a fair complaint.
Timber-clad steel as the alternative
Where the look matters more than the material, a steel or insulated door with a timber-look finish gives the appearance with almost no maintenance. An insulated core gets you much of the acoustic benefit as well, at a lower price and with far less upkeep.
Automating a wooden garage door
Entirely possible, with the operator sized to the finished mass and the door balanced properly first. Balance is the whole job on a heavy door; the motor should be moving a balanced door, not lifting a heavy one.
What a wooden garage door costs in Kempton Park
More than steel, both to buy and to keep. Priced on opening size, timber, construction, finish and automation, with the maintenance expectation set out in writing.
Common questions
About wooden garage doors
Meranti is the sensible all-round choice in South Africa: stable, takes stain evenly and reasonably priced. Cedar is lighter, which matters on a wide double door, and naturally insect-resistant. Saligna is beautiful but heavy. Pine only works under a deep overhang with disciplined recoating.
Look at it once a year. If the finish has gone matt or chalky at the bottom rail or the vertical edges, sand lightly and put two coats on. North- and west-facing doors in Gauteng need it more often than sheltered doors at the coast.
Usually because the back and the end grain were never sealed. Water goes in at the unsealed edges and the board moves. We seal all six faces on the bench before the door is hung, and build the timber onto a galvanised steel frame that carries the load.
No — timber cannot curl around a barrel. A wooden door runs as a tip-up panel or as a hinged sectional door. If you have no headroom for either, a woodgrain-finish aluminium door gives the same look on a roll-up mechanism.
Related
Also worth a look
Industrial Roller Shutter Doors
Isando, Spartan, Croydon, Chloorkop
Heavy-duty galvanised shutters for the airport freight belt, specified by cycle count and span rather than sold off a size chart. Openings to 8 000mm.
- Openings to 8 000mm wide
- 0.8mm–1.2mm galvanised slat
- Chain hoist or motorised
Steel Garage Doors
The workhorse, galvanised and coated
Galvanised steel garage doors in 0.5mm to 0.8mm sheet, Chromadek or powder-coated, built to your measured opening as roll-up, sectional or tip-up. Repairs on any make.
- 0.5mm to 0.8mm galvanised sheet
- Chromadek or powder-coated to any RAL
- Roll-up, sectional or tip-up
Perforated Roller Shutter Doors
Ventilated bays and workshop openings
Perforated curtains for workshops and bays that need airflow and extraction while the opening stays secured overnight.
- Punched galvanised slat, mixed options
- Openings to 6 000mm wide
